PTZ Camera servicing a "snap" with Clip2Fit design

 As solidly built and reliable as a VisionDome PTZ camera by 360 Vision Technology can be, there will come a time where it may need to be serviced. That's when the unique Clip2Fit design comes in handy!

Clip2Fit by 360 Vision Technology All major components are quickly and easily replaced using Clip2Fit design. Main control circuit and power supply boards, motors as well as the slip-ring can be swapped out in a matter of a few minutes - no tools required!

Typically, the slip-ring is the least accessible component within any dome. The 360 VisionDome slip-ring can be replaced within 10 minutes, with minimal training. 

Any required camera maintenance can be carried out by installers ‘onsite’ or back at base to ensure minimum cost and systems downtime.

This same Clip2Fit design allows easy upgrading of any existing 360 VisionDome analog PTZ camera to Active UTP or IP.

For more information on the 360 VisionDome, click here

Leave a comment

Please note, comments must be approved before they are published